777parts.net — оn-line catalog of spare parts for CATERPILLAR, KOMATSU, HITACHI, JOHN DEERE, TADANO, JCB, VOLVO, DOOSAN, HYUNDAI machinery
Attention!
You must be subscriber to view full schemes and spare parts numbers.

Caterpillar 416E

What feature would you like to see on the 777parts next?

2061704 TRIM GROUP-CAB -OPEN ROPS

BACKHOE LOADER Caterpillar 416E
416E Backhoe Loader Single Tilt Center Pivot CBD00001-UP (MACHINE) POWERED BY 3054C Engine OPERATOR STATION
2061704 TRIM GROUP-CAB -OPEN ROPS

206-1704 TRIM GP-CAB -OPEN ROPS
S/N CBD1-UP
PART OF 204-4160, 204-4164, 292-9690, 292-9691 CANOPY AR-OPEN ROPS
AN ATTACHMENT

Aggregate

Part NoPart NamePrice request
2061704TRIM GROUP-CAB -OPEN ROPS 

List of spare parts

Subscribe to get access to the part numbers and schemes.

Unlock Access
#Part NoPart NameQty.
23***89PLATE-SERIAL NUMBER (MACHINE)(PRODUCT IDENTIFICATION)1
(MACHINE MAIN FRAME)
22***50PLATE-SERVICE INFORMATION (MACHINE)(MACHINE)1
(ON SERVICE PLATE ON MAIN FRAME)
25***10FILM-INSTRUCTION (BOOM LOCK)1
(NEXT TO BOOM LOCK ON RH CONSOLE)
25***11FILM-INSTRUCTION (VARIABLE SPEED)1
(ON RH CONSOLE NEXT TO GOVERNOR CONTROL HANDLE)
15***90FILM-IDENTIFICATION (WATER SEPARATOR)1
(ON LH SIDE OF THE MAIN FRAME NEXT TO THE FUEL TANK 20-MM+/-10 FROM THE FUEL TANK
BRACKET & UP FROM THE BOTTOM EDGE OF THE MAIN FRAME 50-MM+/-10)
25***99FILM (LIFT EYE LOCATION)4
(APPLY A TOTAL OF 4 FILMS. THE FIRST 2 FILMS MUST BE APPLIED TO THE FRONT SIDE OF THE FRONT AXLE BETWEEN THE CHASSIS
& WHEEL ASSEMBLY ON THE LH & RH SIDE OF THE MACHINE. THE LAST W FILMS MUST BE APPLIED TO THE STAB PAD CENTERED UNDER
THE LIFTING HOLE ORIENTED WITH THE ARROW POINTING UP WHEN THE STABILIZER IS IN UPWARD POSITION)
25***57FILM-INFORMATION (TIE-DOWN)4
(APPLY 2 FILMS, ONE ON EACH SIDE OF THE MACHINE IN FRONT OF THE MAIN FRAME ABOVE THE FRONT AXLE ABOVE THE TIE DOWN
(MOUNTING PLATE. APPLY THE OTHER 2 FILMS ON THE REAR OF THE MACHINE ON THE MAIN FRAME NEXT TO THE TIE DOWN HOLES UNDER
THE SWING)
25***35FILM-IDENTIFICATION (START SWITCH, READ OMM)1
(ON RH CONSOLE AROUND KEYSWITCH)
28***12FILM-COVER (PROTECT)(BATTERY BOX)1
(PLACE FILM INSIDE BATTERY BOX ON THE LEFT SIDE 150 +/- 5-MM UP FROM THE BOTTOM OF THE BOX)
23***61FILM-IDENTIFICATION (FUSE, RELAY)1
(UNDER RH CONSOLE COVER THAT COVERS THE POWER DISTRIBUTION BLOCK. ORIENT FILM SUCH THAT IT
(CAN BE READ WHEN THE COVER IS OPEN & THE BLOCK IS EXPOSED)
15***33FILM-IDENTIFICATION (12-VOLT)1
(INSIDE BATTERY BOX DOOR CENTERED FROM SIDE TO SIDE ABOVE THE JUMP START WARNING FILM & CENTERED FROM TOP TO BOTTOM
(BETWEEN THE JUMP START FILM & BEND IN THE DOOR)
25***96FILM-IDENTIFICATION (LUBRICATION POINTS)1
(UNDER THE HOOD ON PRE-CLEANER, REMOVE SUPPPLIER FILM & ORIENT FILM SUCH THAT IT CAN BE READ FROM THE LEFT SIDE OF THE
(MACHINE)
23***58FILM-IDENTIFICATION (FUSE PANEL)1
(INSIDE RH CONSOLE ACCESS PANEL. ORIENT FILM SUCH THAT IT CAN BE READ WHILE STANDING
ON THE GROUND WITH THE ACCESS DOOR OPEN & VIEWING FILM)
13***58FILM (IDENTIFICATION) (ON RADIATOR FILLER CAP) (ON NEAR OF RADIATOR FILLER CAP)1
(ON SHUNT TANK NEXT TO RADIATOR CAP ORIENTED SUCH THAT YOU CAN READ IT FROM MACHINE)
22***41FILM-INFORMATION (ROPS, FOPS, READ OMM)1
(ON THE LH A-POST 350+/-5-MM FROM THE FLOOR. THE UPPER FILM SHOULD BE THE NO WELD/NO DRILL
(& THE ROPS/FOPS IN THE LOWER POSITION)
20***24FILM-INFORMATION (BRAZIL)1
(PLACE BRAZILIAN INFORMATION PLATE NEAR THE PIN PLATE)
12***56FILM (WARNING) (NO STEP) (ON TOP OF HOOD BEHIND CAB ON EACH SIDE) (ON EACH FENDER FLARE)1
(POSITION INSIDE BATTERY BOX DOOR 75 +/- 5-MM FROM THE RIGHT EDGE & THE TOP EDGE IS EVEN WITH THE 12 VOLT FILM)
21***02FILM-WARNING (NO WELD, NO DRILL, READ OMM)1
(ON THE LH A-POST 350 +/- 5-MM FROM THE FLOOR. THE UPPER FILM SHOULD BE THE
(NO WELD/NO DRILL & THE ROPS/FOPS IN THE LOWER POSITION)
22***12FILM (WARNING) (JUMP START) (ON OUTSIDE OF BATTERY COMPARTMENT DOOR)1
(INSIDE OF BATTERY BOX DOOR CENTERED ABOVE DOOR LATCH & 75 +/- 5-MM UP FROM THE EDGE OF DOOR)
22***40FILM (WARNING) (CRUSH) (ON EACH SIDE FACE OF NON ENGINE END FRAME)2
(ON BOOM 700-MM +/-5-MM UP FROM CENTER LINE OF SWING & BOOM LOWER FOOT PIN & 150-MM +/-5-MM
(OVER FROM THE OUTER EDGE OF BOOM CENTERED & ORIENTATED SO THAT THE FILM CAN BE READ WHILE STANDING ON THE GROUND)
23***30FILM-WARNING (ARM BRACE, READ OMM)1
(ON SAFETY BRACE CENTERED FROM TOP TO BOTTOM & SIDE TO SIDE)
25***93FILM-WARNING (READ OMM)1
(ON RH CONSOLE UNDER KEYSWITCH IN AREA PROVIDED. UNIVERSAL FILM IS LOCATED ON UPPER
(HALF & THE SEATBELT FILM ON THE LOWER HALF)
25***94FILM-WARNING (SEAT BELT)1
(ON RH CONSOLE UNDER KEYSWITCH IN AREA PROVIDED. UNIVERSAL FILM IS LOCATED ON UPPER
(HALF & THE SEATBELT FILM ON THE LOWER HALF)
25***02FILM-WARNING (HOT FLUID UNDER PRESSURE)1
(ON TOP OF THE RADIATOR SHUNT TANK CAP. ORIENT FILM SO THAT IT CAN BE READ WHILE
(LOOKING AT THE ENGINE AREA FROM THE LEFT SIDE OF THE TRACTOR)
22***46FILM-WARNING (NO ETHER SPRAY/AIR INTK, INTL)1
(UNDER HOOD ON PRE-CLEANER UNDER THE SERVICE FILM. ORIENT FILM SUCH THAT IT CAN BE READ FROM LEFT SIDE OF THE MACHINE)
24***95FILM-WARNING (NO ENTRANCE, EXIT, READ OMM)2
(ON THE REAR OF THE CAB AR THE BOTTOM STRUCTURE 50 +/- 5-MM FROM THE TOWARD RED REFLECTOR)

2061704 TRIM GROUP-CAB -OPEN ROPS - BACKHOE LOADER Caterpillar 416E - 416E Backhoe Loader Single Tilt Center Pivot CBD00001-UP (MACHINE) POWERED BY 3054C Engine OPERATOR STATION | 777parts

Related parts

Spare parts dealers for Caterpillar

Add your company

* To view Caterpillar spare parts dealers contact information you must be registered and logged in.